TM 5-3825-226-24
AXLES
REMOVE AXLES
Tools Needed
A
9S8900
Cylinder Group
1
Fr959
Adapter
1
5F9888
Adapter
1
5F9892
Pin
1
9S5431
Sleeve Assembly
1
9S5433
Adapter
1
6H4158
Pin
1
7B2499
Ring
1
5P3100
Pump Group
1
start by:
a) remove wheel assemblies, bearings and
seals
1.
Bend the tabs of the plate (lock) from bolts (1)
that hold the axle in the frame.
2.
Loosen bolts (1) approximately .25 in. (6.4
mm). Do not remove these bolts.
3.
Install tooling (A) and pull axle (2) loose.
4.
Remove tooling (A), bolts (1), the plate (lock),
plate and shims from inside the frame.
5.
Remove the axle from inside the frame.
6.
Remove the axle from the frame. The weight of
the axle is 50 lb. (23 kg).
INSTALL AXLES
Tools Needed
A
FT959
Adapter
1
5F9889
Plug
1
5F9892
Pin
1
1.
Put the axle (1) in position in the water
distributor frame.
2.
Install the plate and bolts that hold the axle in
the frame.
3.
Install tooling (A) on the end of axle (1).
4.
Hit the axle with a hammer until the bolts that
hold the axle can not be tightened more at a
torque of 200 to 220 Ib.ft. (270 to 295 Nm).
5.
Remove the bolts and plate that hold the axle in
the frame.
6.
Add enough shims behind the plate that holds
the axle to get a minimum distance from the
end of the axle to the plate of .125 in. (3.18
mm).
7.
Install the shims, plate, plate (lock) and bolts to
hold the axle. Tighten the bolts to a torque of
200 to 220 lb.ft. (270 to 295 Nm).
end by:
a) install wheel assemblies, bearings and seals
6-45/(6-46 Blank)