TM 5-3825-226-24
STEER AXLE AND WHEEL
(1)
Do the steps that follow for steer wheel bearing adjustment:
a.
Tighten nut (1) slowly to 70 N-m (50 Ib.ft.) while turning
the wheel.
b.
Loosen nut (1) completely. Tighten it again to 50 ± 5
N-m (37 ± 4 lb. ft.)
c.
Bend the lock over nut (1).
(2)
Add or remove shims (4) until torque required
to turn knuckle assembly
is .............................................4.5 to 6.8 N-m (40 to 60 Ib.in.)
(3)
Torque for nut that holds wheel
to hub.................................... 440 ± 35 N-m (325 ± 25 Ib.ft.)
(5)
Torque for cover bolts
(four)..................................... 135 ± 14 N-m (100 ± 10 Ib.ft.)
(6)
Torque for cover bolts
(two)........................................ 270 ± 20 Nm (200 ± 15 Ib.ft.)
(7)
Adjust stop bolt to get angle (Y) of.................................... 76°
(8)
Torque for steering cylinder mounting
bolts .........................................470 ± 45 Nm(350 ± 35 Ib.ft.)
(9)
Adjust stop bolt to get angle (X) of.................................... 56°
7-7
