TM 5-3825-229-14&P
5-16. FUEL INJECTION PUMP (cont)
a.
Removal.
(1)
Remove plug from flywheel housing. Rotate engine clockwise until timing mark on
flywheel lines up with timing pointer.
NOTE
Number one piston must be on the compression stroke to remove injection pump (see
para.4-47 for this procedure).
(2)
Loosen, but do not remove, four screws (1) from pump drive gear cover (2).
(3)
Remove two screws (1) with flat washers from left side of cover.
(4)
Remove pump drive gear cover (2) by sliding it to the left.
(5)
Remove packing from behind gear cover (2) and discard.
(6)
Remove hex nut from injection pump drive shaft.
(7)
Install three metric capscrews (3) through puller and into injection pump drive gear.
5-43
