PISTONS AND CONNECTING RODS (cont) - TM-5-3825-229-14P

PISTONS AND CONNECTING RODS (cont) - TM-5-3825-229-14P_325

PISTONS AND CONNECTING RODS (cont) - TM-5-3825-229-14P_327

TM-5-3825-229-14P Distributor Water Self-Propelled 2500 Gallon Capacity Sectionalized and Non-Sectionalized Models 613BWDNS Manual
Page Navigation
308

TM 5-3825-229-14&P 6-11. PISTONS AND CONNECTING RODS (cont) d. Assembly (cont). (6) Lubricate piston (8) and rings (5) with engine oil (OE/HDO). Install rings on piston using a piston ring installer. (a) Install oil control ring spring in bottom groove of piston with the guide pin inserted inside spring. (b) Install chrome oil control ring in bottom groove over spring with end gap opposite (180 degrees) the guide pin in spring. (c) Install second compression ring in second groove of piston with side stamped "Up 2nd" or with a dot towards top of piston. (d) Install top chrome compression ring in top groove of piston with side stamped "Up Top" or with a dot towards top of piston. (7) Install bolts (10) in piston rod (3). e. Installation. (1) Stagger piston ring gaps evenly around piston (8). Apply lubricant (OE/HDO) to piston (8) and rings (5). (2) Turn crankshaft to position number one rod bearing journal at the bottom of its stroke. 6-27

Privacy Statement
Press Release
Contact