TM 5-3895-370-14&P4-21. REMOVAL AND DISASSEMBLY OF COMPONENTS (CONT).e.Cotter pins, lockwashers, lockwire, self-locking nuts, and similar devices should be discarded when removed.Self-locking fasteners that loosen up must be replaced, not tightened.f.To prevent moisture and foreign matter from entering open housings, lines, and other openings, use protectivecoverings as soon as possible after disassembly. Wrap all parts in clean paper or dip parts in the fluid in which theynormally operate.g.Remove parts only if repair or replacement is required. Do not disassemble a component any further thannecessary to accomplish needed repairs.4-22. PAINTING.Instructions for preparation of material to paint, how to paint, and material to be used are in TM 43-0139. Instructions forcamouflage painting are contained in FM 5-20. Stenciling and marking military vehicles are listed in TB 43-0209. Dataplate location and description is listed in Chapter 2.4-23. LUBRICATION INSTRUCTIONS.Refer to Lubrication Chart (Figure 3-1) for unit maintenance lubrications.4-48
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
