TM 5-3895-370-14&P
4-65. STARTER REPLACEMENT (CONT).
a. Removal.
NOTE
Tag and mark all wires before
removal.
(1)
Remove nut (1), positive battery cable (2), and
four wires (3) from starter assembly (4).
(2)
Remove nut (5), lockwasher (6), and wire (7)
from starter assembly (4). Discard lockwasher.
(3)
Remove three screws (8) and starter assembly
(4) from flywheel housing (9).
b. Installation.
(1)
Install starter assembly (4) and three screws (8)
on flywheel housing (9). Tighten screws 32 lb-ft
(43 Nm).
(2)
Install wire (7), lockwasher (6), and nut (5) on
starter assembly (4).
(3)
Install four wires (3), positive battery cable (2),
and nut (1) on starter assembly (4).
NOTE
Follow-on maintenance:
·
Connect negative battery cable
(para 4-84).
·
Install rear engine panel (para 3-
6).
END OF TASK
4-156
