RESISTOR BOX REPLACEMENT/REPAIR (cont)

TM-5-3895-370-14P Spreader Aggregate: Towed; 3 Ft Spread FF-8 (NSN 3895-01-329-5096) Manual
Page Navigation
332

TM 5-3895-370-14&P 4-74. RESISTOR BOX REPLACEMENT/REPAIR (CONT). b. Disassembly. (1) Remove grommet (1) from resistor box (2). NOTE This step shows replacement of one resistor. The procedure is the same for all five resistors. (2) Remove two rivets (3), holders (4), and resistor (5) from resistor box (2). Discard rivets. (3) Remove two wires (6) from two resistors (7) and two diodes (8). c. Assembly. (1) Install two wires (6) on two diodes (8) and resistors (7). (2) Install resistor (5) on resistor box (2) with two holders (4) and rivets (3). d. Installation. (1) Install resistor box (6) on main frame (14) with four screws (13), lockwashers (12), and nuts (11). (2) Install resistor/junction cable (10) in resistor box (6). (3) Install cable tie (9) on resistor/junction cable (10). (4) Connect two wires (7) to top resistor (8). (5) Connect wire (4) to bottom resistor (5). (6) Connect two wires (1) on two resistors (2) on cover (3). NOTE Follow-on maintenance: Install 24- volt cable (para 4-87). END OF TASK 4-194

Privacy Statement
Press Release
Contact