TM 5-3895-370-14&P
4-79. TAILLIGHT/TURN SIGNAL ASSEMBLY REPLACEMENT (CONT).
NOTE
Remove spiral cable wrap from wire harness only until taillight snap plug
connectors are visible.
(2)
Remove spiral cable wrap (4) from wire harness (5) and disconnect four wire connectors (6) from wire harness.
NOTE
Washers are located between taillight bracket assembly and bumper.
(3)
Remove four nuts (7), lockwashers (8), and screws (9). Discard lockwashers.
(4)
Remove nut (10), taillight assembly (11), and four washers (12) from bumper (13).
(5)
If damaged, remove nut (14), washer (15), and screw (16)
.
(6)
Remove taillight lamp as follows:
(a)
Remove lens cover (17) from socket
housing (18).
(b)
Remove lamp (19) from socket housing
(18).
b. Installation.
(1)
Install taillight lamp as follows:
(a)
Install lamp (19) in socket housing (18).
(b)
Install lens cover (17) on socket housing
(18).
4-208
