TM 5-3895-370-14&P
c. Installation.
(1)
If removed, install ten studs (17) and plug (16) in
hub (2).
NOTE
Pack bearings and apply a light coat
of grease on outer surface of cups
before installing.
(2)
Install two cups (14 and 15) and bearings (12
and 13) in hub (2).
WARNING
Adhesive sealant, MIL-S-46163, can
damage your eyes. Wear safety
goggles/glasses when using; avoid
contact with eyes. If sealant contacts
eyes, flush eyes with water and get
immediate medical attention.
NOTE
Apply sealing compound to outer
surface of oil seal.
(3)
Using a wooden block, install oil seal (11) in hub
(2).
(4)
Install hub (2) on drum (9) with eight screws
(10). Tighten screws 125 to 135 lb-ft (169-183
Nm).
(5)
With aid of assistant, install drum (9) and hub (2)
as an assembly on axle (8).
4-291
