TM 5-3895-370-14&P
2-9. PREPARATION FOR OPERATION (CONT).
NOTE
·
Ensure that distributor is properly attached to tow vehicle.
·
If flushing material was left in system overnight, proceed to Flushing the
Bituminous System (para 2-26).
(1)
Ensure pump transmission control lever (1) is in neutral position.
(2)
Ensure all valve handles are in the following position (Transfer/Circulate Tank, Figure 2-2, Sheet 3):
(a)
Valve #1 (2) is in tank position.
(b)
Valve #2 (3) is open.
(c)
Valves #3 (4), 4 (5), 5 (6), and 6 (7) are closed.
2-10. JACKSTAND AND EXTENSION JACKS OPERATION AND STOWAGE.
a.
Introduction. The jackstand is used to support
the front end of distributor and to aid in attachment to
tow vehicle. After connecting distributor to tow vehicle,
the jackstand must be properly stowed. The extension
jacks are used to stabilize the distributor during certain
maintenance procedures. The extension jacks must be
stowed properly for vehicle operation.
b.
Jackstand Operation and Stowage.
(1)
To operate jackstand (1), proceed as
follows:
(a)
To raise distributor front end (2),
turn
jackstand
handle
(3),
on
jackstand
(1)
to
the
right
(clockwise).
(b)
To lower distributor front end (2),
turn
jackstand
handle
(3),
on
jackstand
(1),
to
the
left
(counterclockwise).
2-22
