HYDRAULIC VALVE BANK ASSEMBLY REPLACEMENT (cont)

HYDRAULIC VALVE BANK ASSEMBLY REPLACEMENT (cont) - TM-5-3895-370-14P_502

HYDRAULIC VALVE BANK ASSEMBLY REPLACEMENT (cont) - TM-5-3895-370-14P_504

TM-5-3895-370-14P Spreader Aggregate: Towed; 3 Ft Spread FF-8 (NSN 3895-01-329-5096) Manual
Page Navigation
491

TM 5-3895-370-14&P (3) Loosen nut (6) and screw (7) on upper left side of transmission control lever and linkage assembly (8). (4) Remove two screws (9), lockwashers (10), and nuts (11) from control valve (5). Discard lockwashers. (5) Remove control valve (5) from console (3). b. Installation. WARNING Adhesive sealant, MIL-S-46163, can damage your eyes. Wear safety goggles/glasses when using; avoid contact with eyes. If sealant contacts eyes, flush eyes with water and get immediate medical attention. NOTE Apply sealing compound to threads of screws prior to installation. (1) Install control valve (5) on console (3) and secure with two nuts (11), lockwashers (10), and screws (9). Tighten screws 75 to 85 lb-ft (102- 115 Nm). (2) Tighten screw (7) and nut (6) on upper left side of transmission control lever and linkage assembly (8). NOTE Apply hydraulic sealant to threads of fittings prior to installation. (3) Install ten hoses (4) on control valve assembly (5). 4-353

Privacy Statement
Press Release
Contact