TM 5-3895-370-14&P4-136. HYDRAULIC HOSES AND FITTINGS REPLACEMENT.This task covers:a. Removalb. InstallationINITIAL SETUPToolsMaterials/PartsTool kit, general mechanic's: automotiveSealant, hydraulic (item 48, Appendix E)Shop equipment, automotive maintenance andrepair: organizational maintenance supplementalEquipment Conditionno. 1, less powerTM or ParaCondition DescriptionWheels chocked.Shop equipment, automotive maintenance and Para 2-10Jackstand andrepair: organizational maintenance commonsupport jacks lowered.no. 1, less powerPara 3-6Engine off.Para 4-143Drain hydraulic tank.Suitable container 1 gal (3.8 l)The distributor is equipped with many of the same type of hydraulic hoses and fittings. The following procedures coverthe general removal and installation of these hydraulic hoses and fittings. Table 4-6 shows the routing of all hydraulichoses and lists their point of connection.WARNINGHydraulic fluid is very slippery and can cause falls. To avoid injury, wipe upspilled fluid with rags.NOTE·The distributor is equipped with many of the same type of hydraulic hoses andfittings. The following procedure applies to the removal and installation of allhydraulic hoses and fittings.·Subparagraphs a. and b. show typical connections for hoses and fittings ondistributor.·This procedure is for reference only to show location of hoses and fittingsused on distributor. It will never be necessary to remove all hydraulic hoses atone time. Individual procedures will indicate the area where hoses are to beremoved and installed.·Place suitable container with a 1 gal. (3.8 l) capacity under any hydraulic hosethat is being disconnected to catch spilling hydraulic fluid.4-357
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
