ENGINE OPERATING PROCEDURES (CONT)

TM-5-3895-370-14P Spreader Aggregate: Towed; 3 Ft Spread FF-8 (NSN 3895-01-329-5096) Manual
Page Navigation
42

TM 5-3895-370-14&P 2-14. ENGINE OPERATING PROCEDURES (CONT). (2) Turn key switch (3) on gage panel (4) fully to the right. (3) Depress reset button (5) and start button (6) at the same time. (4) Once engine starts, release start button (6) while continuing to depress reset button (5). (5) Allow engine to idle for 30 seconds while holding reset button (5) down. CAUTION If engine oil pressure has not reached 10 psi (69 kPa) after 60 seconds of operation, shutdown distributor by turning key switch fully to the left (counterclockwise) and notify unit maintenance. NOTE If reset button is released before engine oil pressure reaches 10 psi (69 kPa), engine will stall. (6) When oil pressure gage (7) has reached 10 psi (69 kPa), release reset button (5). (7) Allow engine to idle at 1200 RPM for approximately 5 minutes. (8) Ensure that engine will run up to 2100 RPM by temporarily turning throttle control (8) on control console (2) then return engine RPM to 1200. (9) Perform operator PMCS procedures designated During in the Interval column (Table 2-2). (10) Turn flow rate indicator light switch (9) to ON. b. Engine Shutdown. Turn key switch (3) on gage panel (4) fully to the left (counterclockwise). 2-28

Privacy Statement
Press Release
Contact