TM 5-3895-370-14&Pc. Cleaning/lnspection.WARNING·Drycleaning solvent (P-D-680) is TOXIC and flammable. Wear protective gogglesand gloves; use only in a well-ventilated area; avoid contact with skin, eyes, andclothes and do not breathe vapors. Keep away from heat or flame. Never smokewhen using solvent; the flash point for type I drycleaning solvent is 100°F (38°C)and for type II is 140°F (60°C). Failure to do so may result in injury or death topersonnel. P-D-680 type III is a substitute for types I and II in this application. Theflash point for type III is 200°F (93°C).·If personnel become dizzy while using cleaning solvent, immediately get fresh airand medical help. If solvent contacts skin or clothes, flush with cold water. Ifsolvent contacts eyes, immediately flush eyes with water and get immediatemedical attention.(1)Clean all metal parts with drycleaning solvent.WARNINGCompressed air used for cleaning purposes will not exceed 30 psi (207 kPa). Useonly with effective chip guarding and personal protective equipment(goggles/shield, gloves, etc.).(2)Dry all parts with compressed air.(3)Check all parts for damage.(4)Replace damaged parts.d. Assembly.(1)Press seal (42) into pump housing (20).(2)Install washer (41), sealing washer (40), andscrew (39) into pump housing (20).(3)Install two bearings (38) and seals (37) in pumphousing (20).(4)Press bearing cup (36) into pump housing (20).(5)Press bearing cone (35) onto pump shaft (30).5-115
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
