TM 5-3895-370-14&P
5-37. HYDRAULIC VARIABLE-SPEED PUMP REPLACEMENT/REPAIR (CONT).
(5)
Loosen two nuts (15 and 16) and remove two
45 elbows (17 and 18) from variable-speed
pump (11).
(6)
Remove and discard two preformed packings
(19 and 20) from two elbows (17 and 18).
(7)
Remove two tees (21 and 22) and reducers (23)
as an assembly from variable-speed pump (11).
(8)
If damaged, remove two reducers (23) from two
tees (21 and 22).
(9)
Remove and discard two preformed packings
(24) from two reducers (23).
b. Disassembly.
(1)
Matchmark charge pump housing (1) and pump
end cap (2).
(2)
Remove four screws (3) and charge pump
housing (1) from pump end cap (2).
(3)
Remove and discard preformed packing (4) from
charge pump housing (1).
CAUTION
Gerotor
comes
immediately
disassembled.
Use
caution
in
removing gerotor assembly. Failure
to comply may result in damage to
gerotor.
(4)
Remove gerotor assembly (5) and pin (6) from
charge pump shaft (7).
5-110
