TM 5-3895-370-14&P
(18)
Tighten 10 bearing cap screws (2) on five
bearing caps (3) in the following steps:
(a)
Step 1: 44 lb-ft (60 Nm).
(b)
Step 2: 88 lb-ft (119 Nm).
(c)
Step 3: 129 lb-ft (176 Nm).
(19)
Tighten eight screws (6) on four connecting rods
(8) in the following steps:
(a)
Step 1: 26 lb-ft (35 Nm).
(b)
Step 2: 51 lb-ft (70 Nm).
(c)
Step 3: 73 lb-ft (100 Nm).
(20)
Measure side clearance between connecting rod
(8) and crankshaft (1) as indicated. Side
clearance limits are 0.004 to 0.012 in. (0.102
0.305 mm). If measurement is above or below
limits, loosen screws (6), check connecting rod,
and reinstall or replace. If measurement is still
out of limits, replace crankshaft.
5-275