7.
Connect the horn securely to the hose and place the hose in the mounting clips provided. The temporary shut-off
on horn should be left in the closed position.
8.
Make certain that control head is in “set” position. (See detailed instructions under "Reinstallation of Cylinders”).
Mount the control head on the control head outlet of the cylinder valve
9.
After horn, hose and piping are integrally connected, mount discharge heads on cylinder valves following directions
stamped on swivel nut of discharge head. (Older type discharge heads containing multi-hole corprene gasket must
be tightened securely using at least an 18" wrench. New type discharge heads containing two greased rubber rings
should be brought up only snug tight.) Connect hose, flexible loops, or piping to discharge head outlets.
10.
Check installation to make certain that all connections are secure and that the installation has been made in
accordance with these instructions and enclosed drawings.
