Figure 2-79. Removal of 125 GPM Pumping Assembly and Hypochlorination Unit.

Figure 2-78. Flushing of Hypochlorination Unit (Model 1955-1 Shown).

Preparation for Movement of Distribution Points

TM-10-4320-303-13 Tactical Water Distribution Equipment System (TDWS) Set 10-Mile Segement Model 06749-0813-81 110-00-0000 919 and 10 Manual
Page Navigation
130

TM 10 4320-303-13 x. Push cam arms on female quick-disconnect coupling half (15) forward to open. Remove 2 inch gate valve (14) with attached male quick-disconnect coupling half (13) and female quick-disconnect coupling half (15) from end of Y- connection (16). y. Remove male quick-disconnect (13) and female quick-disconnect (15) coupling halves from ends of 2 inch gate valve (14). z. Push both sets of cam arms on elbow valves (16) forward to open. Remove two dust plugs (17) from ends of elbow valves (16). aa. Remove elbow valves (16) from ends of two hose assemblies (18). ab. Repeat steps u through y to disconnect hose assemblies (18), Y-connection (19), hose assembly (20), 2 inch gate valve (21), male quick-disconnect (22) and female quick-disconnect (23) coupling halves. ac. Push cam arms on Y-connection (16) forward to open. Remove Y-connection (16) from end of hose assembly (1). ad. Refer to applicable technical manual and shut down 125 GPM pumping assembly. Figure 2-79. Removal of 125 GPM Pumping Assembly and Hypochlorination Unit. NOTE If disconnecting hypochlorination unit model 1955-1 or model A-506131 perform steps ae and af. If disconnecting hypochlorination unit model 1955-3 perform steps ag through aj. ae. Push cam arms on inlet port female quick-disconnect coupling half (Figure 2-79, 1) forward to open. Remove hose assembly (2) from female quick-disconnect coupling half (1) on inlet port of hypochlorination unit (3). af. Remove female quick-disconnect coupling half (1) from hypochlorination unit (3) inlet port. 2-113

Privacy Statement
Press Release
Contact