TM 10 4320-303-13
Figure 3-3. Male Quick-Disconnect Coupling Half and Banding Installation.
g. Drain hose ends (3) and wipe dry.
h. Insert male-end of quick-disconnect coupling half (Figure 3-3, 1) into hose end (2), until shoulder (3) is
flush with hose end (2).
i. Cut strapping to sufficient length to accommodate double wrap around hose and have an additional 10
inches of strapping.
j. Bend strapping approximately 2 inches from either end.
k. Install buckle on opposite end of strapping. Slide buckle to bend ensuring ears of buckle are up and in
bend of strapping.
l. Place both ends of strapping (4) through buckle (5).
Figure 3-4. Strapping Preparation.
3-7
