TM 10-4320-303-13
3.4.1.2 Hose Repair Using Double-Ended Adapter Repair.
NOTE
If leak is caused by a small puncture, cut hose at puncture.
a. Refer to paragraph 3.4.1.1 and perform steps a through g.
Figure 3-12. Double-Ended Adapter Installation.
b. Insert one end of double-ended adapter (Figure 3-12, 1) into hose end (2), until shoulder (3) is flush hose
end (2).
c. Refer to paragraph 3.4.1.1 and perform steps i through v.
d. Refer to paragraph 3.4.1.1 and perform steps a through g to install hose (2) on other end of double-ended
adapter (1).
e. Refer to paragraph 3.4.1.1 and perform steps i through v.
f. Release hose clamps (Figure 3-1, 1) and inspect repaired section for leaks.
3.5 STORAGE ASSEMBLY MAINTENANCE .
Refer to applicable technical manual for operator maintenance procedures for the 20,000 gallon pillow tank
maintenance.
3.6 125 GPM PUMPING ASSEMBLY MAINTENANCE.
Refer to applicable technical manual for operator maintenance procedures for the 125 GPM pumping
assembly.
3-12
