TM 10-4320-303-13
4.13.2 Outlet, Pressure Regulator, Inlet, Drain, and Fill Hose Assemblies Maintenance .
This task covers:
4.13.2.1 Removal
4.13.2.2 Inspection
4.13.2.3 Installation
INITIAL SETUP
Tools
Equipment Conditions
Tool Kit, General Mechanic's,
Hypochlorination Unit, Model 1955-1 removed,
Automotive, Section III, Item 1,
refer to paragraph 4.13.1.
Appendix B
General Safety Instructions
Material/Parts
Do not work on equipment without following
Antiseize Tape, Item 9, Appendix E
standard shop safety precautions.
4.13.2.1 Removal.
NOTE
This procedure is applicable to the outlet hose assembly. The procedures for
the pressure regulator, inlet, drain, and fill hose assemblies are similar.
Figure 4-15. Outlet Hose Assembly Maintenance.
a. Loosen two hose clamps (Figure 4-15, 1) and slide them back from hose connectors (2 and 3).
b. Remove outlet hose (4) from hose connectors (2 and 3).
c. Remove two hose clamps (1) from outlet hose (4).
d. Remove hose connectors (2 and 3).
4-39
