TM 10-4320-303-13
4.13.2 Outlet, Pressure-.Regulator, Inlet. Drain, and-Fill Hose Assemblies Maintenance . (Continued)
4.13.2.2 Inspection.
a. Inspect two hose clamps (1) for corrosion, damage, and missing components.
b. Inspect hose connectors (2 and 3) for corrosion, 6cracks, or damage.
c. Inspect outlet hose (4) for holes, cracks, slices, tears, or damage.
4.13.2.3 Repair.
a. Replace defective outlet hose (4) length.
b. Replace defective or damaged hose clamps (1) and hose connectors (2 and 3).
4.13.2.4 Installation.
NOTE
Wrap antiseize tape in direction of threads.
a. Wrap antiseize tape around threads of hose connectors (2 and 3) and install hose connectors (2 and
3).
b. Place two hose clamps (1) on replacement piece of outlet hose (4).
c. Install outlet hose (4) on hose connectors (2 and 3).
d. Slide two hose clamps (1) over outlet hose (4) and hose connectors (2 and 3) interface. Tighten hose
clamps (1).
4-40
