TM 10-4320-303-13
4.13.3 Pressure Gauge and Fill Assembly Replacement. (Continued)
f. Remove close nipple (7) from inlet nipple (8).
4.13.3.2 Inspection.
a. Inspect pressure gauge (1) for cracked face, holes, or damage.
b. Inspect globe valve (4) for corrosion, smooth operation of handle, cracks, holes, or damage.
c. Inspect all piping hardware for corrosion, cracks, holes, bends, or damage.
d. Replace all defective or damaged components.
4.13.3.3 Installation.
NOTE
Wrap all threaded portions of pressure gauge and fill assembly components
with antiseize tape prior to installation.
Wrap antiseize tape in direction of threads.
a. Install close nipple (7) on inlet nipple (8).
b. Install pipe tee (6) on close nipple (7).
c. Install close nipple (5) on pipe tee (6).
d. Install globe valve (4) on close nipple (5).
e. Install nipple (3) on pipe tee (6).
f. Install elbow (2) on nipple (3).
g. Install pressure gauge (1) on elbow (2).
4-42
