Lead Pumping Station Assembly . (Continued)

Figure 2-17. TWDS Water Source Connection Components Assembly.

Figure 2-18. Boost Pumping Station and Suction Components Assembly

TM-10-4320-303-13 Tactical Water Distribution Equipment System (TDWS) Set 10-Mile Segement Model 06749-0813-81 110-00-0000 919 and 10 Manual
Page Navigation
61

TM 10-4320-303-13 2.3.4 Lead Pumping Station Assembly . (Continued) CAUTION To prevent leakage, close both cam arms at the same time. Do not strike cam arms to close. Damage to couplings could result. p. Connect last 6 inch suction hose assembly (5) to Y-connection reducer (6) (6 inch x 4 inch x 4 inch). Close cam arms. q. Connect Y-connection reducer (6) to water source. Close cam arms. 2.3.5 Boost Pumping Station Assembly . Each boost pumping station assembly requires one trailer-mounted pumping assembly, and the tools, personnel, and components listed below. Remove the required components from the "PUMPING STATION" crate. Perform inspections of each part for damage and operability. 2.3.5.1 Assembly Requirements. Tools Used To Rubber Mallet and Clamping Tool (Items Install 6 inch grooved-end pipe quick 157 and 3, Appendix C) disconnect coupling clamps. Personnel Two required Components Table 2-10. Components Required From Pumping Station Crate for Assembly of Boost Pumping Station. Qty Size Item 3 6 inch Butterfly valve 1 6 inch Check valve 1 6 inch x 10 foot Hose assembly 1 6 inch x 20 foot Hose assembly 1 6 inch x 75 foot Hose assembly 12 6 inch Grooved-end pipe quick disconnect coupling clamp 2 6 inch Lateral grooved pipe fitting 1 6 inch Pressure relief valve and nipple 2.3.5.2 Assembly and Installation Procedures. Refer to applicable technical manual for assembly, installation, and preparation for use of the model 600 gpm pumping assembly supplied with your TWDS. 2-44

Privacy Statement
Press Release
Contact