Table 2-11. Components Required from Storage Assembly Crate for Assembly of Storage Assembly

Figure 2-20. Boost Pumping Station and Bypass Components Assembly.

Figure 2-21. Storage Assembly Connection Components Assembly

TM-10-4320-303-13 Tactical Water Distribution Equipment System (TDWS) Set 10-Mile Segement Model 06749-0813-81 110-00-0000 919 and 10 Manual
Page Navigation
65

TM 10-4320-303-13 Components Table 2-11. Components Required from Storage Assembly Crate for Assembly of Storage Assembly. Qty Size Item 16 0.375 16 UNC-2A Bolt X 3.25 inches 1 4 inch Coupling half, female, quick disconnect 1 4 inch Coupling half, male, quick-disconnect 1 4 inch Coupling pipe fitting NOTE Required number of discharge hose assemblies depends on distance between hoseline segment and storage assembly. Any unused hose assemblies can be used as spares. 4 4 inch x 10 foot Discharge hose assembly, quick disconnect 1 4 inch Male flanged coupling half 32 0.046 ID x 0.812 Flat washer OD 2 4 inch, Class 150 Gasket 1 4 inch Gate valve, flanged 1 4 inch Grooved-end pipe quick disconnect coupling clamp 16 0.375 16 UNC-2B Hex nut 1 6 inch x 6 inch Reducing tee 2.3.6.2 Assembly and Installation Procedures. CAUTION To prevent damage to storage assembly, DO NOT choose site subject to flooding or high water. To prevent damage to storage tank, DO NOT walk on tank unless you must. DO NOT drop sharp objects on tank. After removing components from boxes, be sure to protect them from sand and grit. a. Place gasket (Figure 2-21, 14) on male flanged coupling half (18). Place 4 inch gate valve (12) on male flanged coupling half (18). Align holes of 4 inch gate valve (12), gasket (14), and male flanged coupling half (18). b. Place eight flat washers (17) on eight bolts (19). Insert bolts through openings on male flanged coupling half (18), gasket (14), and 4 inch gate valve (12). 2-48

Privacy Statement
Press Release
Contact