TM 10-4320-303-13CAUTIONTo prevent leakage, close both cam arms at the same time.Do not strike cam arms to close. Damage to couplings could result.p. Connect female flanged coupling half (4) on the last 4 inch x 10 inch discharge hose assembly (3)with male flanged coupling half attached to 4 inch gate valve assembly (5). Close cam arms.NOTEHose-laying crew should provide enough slack in hoseline to allow for connectionof reducing tee/gate valve assembly.q. Move reducing tee/4 inch gate valve assembly (5) to a location that will be out of the way of hose-laying crews.2.3.7 Assembly of Distribution Points. Assembly of a distribution point requires the tools, personnel, andcomponents listed below. Remove the required components from the "DISTRIBUTION POINT” crate. Performinspection of each part for damage and operability. Reference applicable technical manual for assembly,installation, and preparation for use of the 125 GPM pumping assembly. Reference applicable technicalmanuals for the assembly and preparation for use of hypochlorination unit models 1955-3 and A-506131.2.3.7.1 Assembly Requirements.ToolsUsedToPipe wrench, 1 inch minimumInstall components with threaded fittings.and 2 inch maximum(Notify unit maintenance to install components with threaded fittings).PersonnelTwo requiredComponentsTable 2-12. Components Required from Distribution Point Crate for Assembly of Distribution Points.QtySizeItem1Color comparator kit24 inch x 2 inchReducer, male by female and female by male, quick disconnect12 inch x 20 feetHose assembly32 inchCoupling half, quick disconnect, female external pipe thread32 inchCoupling half, quick disconnect, male external pipe thread12 inch x 10 feetSuction hose assembly22 inch x 4 inchReducer, male by female and female by male, quick disconnect14 inchCoupling half, quick disconnect, female internal pipe thread14 inchNipple1100 gpmHypochlorination Unit2-51
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
