TM 10-4320-303-132.3.7 Assembly of Distribution Points. (Continued)NOTEWrap antiseize tape in direction of threads.g. Wrap antiseize tape (item 9, appendix E) around threads on female quick disconnect coupling half(7). Screw female quick-disconnect coupling half (7) into suction port (4) of 125 GPM pumpingassembly (6).h. Push cam arms on female quick-disconnect coupling half (7) forward to open position.CAUTIONTo prevent leakage, close both cam arms at the same time.Do not strike cam arms to close. Damage to couplings may result.i. Connect rigid-walled hose assembly (3) to female quick-disconnect coupling half (7) on 125 GPMpump (6). Close cam arms.NOTEWrap antiseize tape in direction of threads.j. Wrap antiseize tape (item 9, appendix E) around threads on male quick disconnect coupling half (8).Screw male quick-disconnect coupling half (8) into discharge port (5) of 125 GPM pumping assembly(6).CAUTIONTo prevent leakage, close both cam arms at the same time.Do not strike cam arms to close. Damage to couplings may result.k. Connect discharge hose (9) to male quick-disconnect coupling half (8) on 125 GPM pumpingassembly (6). Close cam arms.NOTEIf installing hypochlorination unit 1955-3, refer to steps 1 through w. If installinghypochlorination units 1955-1 or A-506131 refer to steps x through ad.l. Locate inlet port (10) and outlet port (11) on hypochlorination unit 1955-3 (12). Refer to applicabletechnical manual for preparation for use of hypochlorination unit 1955-3.NOTEWrap antiseize tape in direction of threads.m. Wrap antiseize tape (item 9, appendix E) around threads on both ends of pipe nipple (16). Screwpipe nipple (16) into hypochlorination unit 1955-3 (12).n.Screw female quick-disconnect coupling half (17) onto pipe nipple (16).o.Push cam arms on female quick-disconnect coupling half (17) forward to open position.2-54
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
