SERVICE MANUAL
SERVICE INSTRUCTIONS
ASSEMBLING UNIVERSAL JOINT - MEDIUM
AND HEAVY DUTY (Figs. 21, 22 and 23)
1.
SEAL - If necessary to install a new kit make sure
that four new seals are installed in the journal
retainers.
Fig. 21
2.
JOURNAL CROSS - With the relief valve facing the
flange yoke, insert one trunnion of the journal cross
into the bearing hole in the yoke lug from the inside
between the lugs and tilt until the trunnion of the
journal cross will clear the hole in the opposite yoke
lug.
Fig. 22
3.
NEEDLE BEARING AND RETAINING CAP SUB-
ASSEMBLY - Insert from outside of yoke. Press into
place with an arbor press or tap with a soft round
drift taking care not to mar any surfaces.
4.
LOCK STRAP AND CAPSCREWS - Assemble and
bend the lugs of the lock strap up against the flat of
the capscrew. If the joint appears to bind, tap the
lugs lightly to relieve any pressure of the bearing on
the end of the journal.
BEARING CAP CONSTRUCTION
MEDIUMA ND HEAVY
Fig. 23
CTS-4017 - Page 14
PRINTED IN UNITED STATES OF AMERICA
