SERVICE MANUALFig. 281End Yoke7Snap Ring2U-Bolt8Sleeve Yoke3Nut9Cork Washer4Lock Washer10 Steel Washer5Bearing Assembly11 Dust Cap6Journal AssemblyCLEANING AND INSPECTION1.Clean All Parts - Use a suitable cleaning fluid. Allowthe parts to remain in the cleaner for some time toloosen up any particles of grease or foreign matter.Re-move any burrs or rough spots from anymachined surfaces.2.Needle Bearings - Do not disassemble. Clean withshort stiff brush and blow out with compressed air.Work a small quantity of lubricant into each bearingcap and turn the needle bearing on the trunnion tocheck wear. Replace if worn.3.Journal Cross - Because worn needle bearings usedwith a new journal cross or new needle bearingsused with a worn journal cross will wear more rapidlymaking another replacement necessary in a shorttime, always replace the journal cross and fourneedle bearing caps as a unit.4.Journal and Bearing Kit (Figs. 29 and 30) - Tofacilitate the replacement of journals and bearings, aJournal and Bearing Kit is available. The use of theKit insures having the correct individual parts whenrequired and saves valuable time.Fig. 30CTS-4017 - Page 16PRINTED IN UNITED STATES OF AMERICA
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
