Fig. 16 Clutch Pedal Shaft Details

TM-5-3820-256-24-4 Drilling System Well Rotary Truck Mounted Air Transportable 600 Feet Capacity Model LP-12 NSN 3820-01-246-4276 Manual
Page Navigation
395

SERVICE MANUAL Fig. 16 Clutch Pedal Shaft Details 1 SPACER, Pedal (W/Air Brakes) PEDAL, Brake (W/Hyd. Brakes) 2 BUSHING (2) 3 TUBE, Spacer 4 PEDAL, Clutch 5 BOLT, Pedal Shaft NUT, Lock 6 SPRING, Return 7 PAD, Pedal 8 BUMPER, Pedal Stop 9 PIN, Clevis (3/8 x 1.0625) PIN, Cotter (3/32 x 1.25) 10 ROD, Clutch, Upper 11 SEAL, Clutch Rod RETAINER, Seal 12 SCREW (3) 13 BRACKET, Steering Column Support 8. Lubricate inside and outside diameters of new bushings with a light coat of grease. Use IH 251H EP grease or an equivalent NLGI #2 multi- purpose lithium grease. 9. Position spacer tube and bushings in bore(s) of pedal(s). 10. Position clutch pedal (with bushings), brake pedal (with bushings) or pedal spacer and spacer tube into steering column support bracket and install pedal shaft bolt and lock nut. 11. Tighten pedal shaft lock nut to specified torque (see BOLT TORQUE CHART). Be sure pedal(s) pivot(s) freely after tightening lock nut. 12. Connect brake pedal to brake cylinder rod (where used). Adjust brake pedal free travel if necessary. 13. Connect brake pedal return spring (where used). 14. Connect clutch pedal to upper clutch rod and install new cotter pin. Lubricate clevis pin with a light coat of grease. 15. Connect clutch pedal return spring. 16. Check clutch control adjustments and readjust as needed (see ADJUSTMENT). RELAY SHAFT BUSHING REPLACEMENT CTS-4050 - Page 11

Privacy Statement
Press Release
Contact