SERVICE MANUALDISASSEMBLYSection 2GOVERNOR DISASSEMBLY1.Using 10 mm Allen wrench, remove plug fromrack link adjustment access hole in top ofgovernor housing.2.Remove seal wire and remove 4 aneroidassembly to governor housing screws (Figure 6).3.Move control lever fully back against low idlestop screw.Figure 6. Aneroid Mounting1.Intermediate Housing2.Mounting Screws3.Seal WireCaution should be exercised when removing aneroidassembly from governor housing not to damage link.4.Turn aneroid assembly slightly counterclockwiseand unlock link from rocker arm guide pin beforetrying to remove (Figures 7 and 8).Figure 7. Aneroid Assembly1.Link2.Rocker Arm Guide Pin Slot3.Maximum Fuel Stop SurfaceFigure 8. Removing Aneroid1.Aneroid Assembly2.Link3.Rocker Arm Guide Pin5.Remove slotted screw guide pin (Figure 9) fromgovernor cover. Use large screwdriver to fit slotof this screw which has been sealed in placewith Loc-Tite Red.CGES-375Printed in United States of AmericaPage 6
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
