SERVICE MANUAL
DISASSEMBLY
Section 2
Figure 17.
1.
Governor Housing
IMPORTANT
BE
CAREFUL
NOT
TO
DAMAGE
EXPOSED CONTROL RACK GUIDE
PIN WHEN GOVERNOR IS REMOVED
FROM THE PUMP.
Pump Disassembly
14.
Remove
camshaft
rear
bearing
nut
and
lockwasher (Figure 18) if rear bearing is to be
replaced.
Figure 18. Removing Rear Bearing Nut and Lockwasher
1.
32 mm Socket
15.
Assemble side puller KDEP 1056 to plug (Figure
19). Remove side plug by inserting collet jaws
into side of plug. Tighten wing nut until jaws grip
plug. Hold handle and turn shaft with a 27 mm
wrench until plug is free. Repeat for other two
plugs.
Figure 19. Removing Side Plugs
1.
KDEP 1056
16.
Remove tappet spacer block from side plug hole
with long nose pliers (Figure 20).
Figure 20. Removing Tappet Spacer Block
1.
Tappet Spacer
CGES-375
Printed in United States of America
Page 9
