SERVICE MANUAL
DISASSEMBLY
Section 2
Figure 13. Removing Guide Bushing
1.
Guide Bushing Support
2.
Guide Bushing
11.
Using KDEP 2988 remover tool on slotted
cylindrical nut and holding the camshaft with a
wrench at the front of the pump to keep it from
rotating, remove the cylindrical nut (Figure 14)
and spacer shim under the nut.
Figure 14. Removing Cylindrical Nut
1.
Cylindrical Nut Remover KDEP 2988
12.
Install KDEP 2886 governor flyweight remover
tool (Figure 15) and remove flyweight assembly.
Since governor weight assembly is serviced as a
complete unit, no further disassembly is required
until rebuild.
Figure 15. Removing Governor Flyweight Assembly
1.
Governor Flyweight Remover Tool KDEP-2886
13.
To remove governor housing remove rack link
and unscrew eight governor housing to pump
housing mounting screws. Remove governor
housing and bracket (Figures 16 and 17).
NOTE: Governor housing screws are locktited.
Governor housing will not have to be removed
from pump housing unless governor housing is
damaged or cracked, fuel dilation is suspected,
there are other leaks, or camshaft bearing
damage is evident.
Figure 16.
1 & 2. Capscrews
CGES-375
Printed in United States of America
Page 8
