GEAR & CASE
SECTION VIII
REASSEMBLY
1.
Place the countershaft subassembly into the
case.
2.
Position the reverse idler gear and thrust
washers in the case Then, install the idler shaft
with the flat side facing the bearing cap.
3.
Assemble the countershaft rear bearing cap,
gasket and shims.
4.
Install
the
lubrication
spacer
into
the
countershaft front bearing bore.
5.
Assemble the clutch housing and gasket to the
case.
6.
Check the countershaft end play. End play
must
be
set
between
.001"
to
.008".
Adjustments can be made by re-shiming if
necessary.
22