SERVICE MANUAL
HOOD AND HINGE MOUNTINGS
Tilt type hoods (Figs. 3 & 4) used with S-Series cabs are
one-piece molded fiberglass units. While they may vary
slightly in size, appearance and hinge mounting, they are
similar in servicing as follows:
HOOD OPENING (TILTING)
The hood assembly is hinged near bumper and can be
tilted by releasing hood latches on
cowl panels. Place foot on bumper step, grasp handle
recess and pull complete hood, fenders and grille
assembly to front. There are two hood stop cables to
prevent over-travel of hood.
To lower hood, push the hood towards cab and at
the same time hold back at handle recess to ease the
hood into traveling position. Secure both hood latches at
cowl panels. Do not allow hood to drop into place or
damage can result.
Fig. 4. Hood Hinge Types For 200 Cm (80 Inch) Wide Cabs
Key
Description
Key
Description
1
Hood, Assembly
1
Hood, Assembly
2
Hinge, Hood Half
2
Support, Radiator
3
Hinge, Frame Half
3
Bracket, Stay Rod Mounting
4
Lubricator
4
Rod, Stay
5
Sidemember, Frame
5
Hinge, Frame Half
6
Bracket, Hinge-to-Frame
6
Sidemember, Frame
7
Nut, Slotted
7
Hinge, Hood Half
8
Spacer
8
Pin, Hood Hinge
9
Spring, Tension
10
Bracket, Hinge
11
Insulator
12
Washer
13
Pin, Hood Hinge
CTS-4065
PRINTED IN UNITED STATES OF AMERICA
Page 6
