Fig. 12. Removing Rear Run Channel

Fig. 13. Removing or Installing Window Glass

TM-5-3820-256-24-5 Drilling System Well Rotary Truck Mounted Air Transportable 600 Feet Capacity Model LP-12 NSN 3820-01-246-4276 Manual
Page Navigation
520

SERVICE MANUAL INSTALL Cab hinge and door installation is accomplished by reversing the foregoing removal procedures. Before final tightening hinge mounting bolts, check the door adjustment. See CAB DOOR ADJUSTMENT for complete details. DOOR GLASS REMOVE 1. Remove door trim as covered previously. 2. Remove rubber insert from around door access cover. Use blunt nose screwdriver or seal tool as shown (Fig. 10). Lift out cover and remove seal from access opening. 3. Lower window glass to bottom of its channel. 4. Working thru access opening remove two glass fastener screws from window guide and detach guide from glass and window regulator lever (Fig. 11). Fig. 10. Removing Access Panel from Door 1. Seal Tool 3. Seal 2. Insert 5. Remove button plug from side of door for access to rear glass run channel upper retaining bolt. Remove bolt. 6. Remove two retaining bolts from lower end of glass rear run channel. Remove channel and channel seal (Fig. 12) from glass and lay aside in door. Fig. 11. Removing Window Guide from Window Glass 1. Regulator Lever 2. Window Glass 3. Window Guide 4. Door Access Opening 5. Fasteners Fig. 12. Removing Rear Run Channel 1. Rear Run Channel 2. Channel Seal 7. Remove glass from front run channel. 8. Pull glass out bottom of access opening (Fig. 13). CTS-4065 PRINTED IN UNITED STATES OF AMERICA Page 10

Privacy Statement
Press Release
Contact