SERVICE MANUAL
Fig. 22. Removing Latch Assembly
1.
Remote Control to Latch Rod
2.
Lock Cylinder to Latch Rod
3.
Lock Knob to Latch Rod
5.
Remove five socket head screws and detach
door latch assembly from inside of door frame
(Fig. 22). Latch jaws should be closed.
INSTALL (Refer to Fig. 19 for Component Details)
1.
Position latch assembly to inside of door. Latch
jaws must be closed and the three relay control
rods should be preassembled to latch.
2.
Pilot threaded end of upper lock knob rod
through lock knob hole in window frame while
positioning latch. Install lock knob.
3.
Secure latch assembly in door with five socket
head screws.
4.
Position remote control assembly in door and
secure with three socket head screws.
5.
Connect the two remaining relay control rods to
remote control assembly and to lock cylinder
lever. Secure rods with rod end clips.
6.
Operate latch assembly to assure correct
assembly.
DOOR OUTER HANDLE
The door outer handle (Fig. 23) is a combination
handle and lever operating assembly that connects with
the latch assembly mechanism inside door to actuate the
latch jaws. Outer handle can be removed without
removing latch assembly.
Fig. 23. Door Outer Handle & Lock Cylinder
1.
Lock Cylinder Retainer
2.
Lock Cylinder to Latch Rod
3.
Nut with Washer
4.
Door
5.
Door Outer Handle Assembly
6.
Rod End Clip
7.
Lock Cylinder Assembly
REMOVE
1.
Remove door hardware, trim and access door
(same as for removing door glass).
CTS-4065
PRINTED IN UNITED STATES OF AMERICA
Page 15