Fig. 46. Side Panel to Roof Inner Panel Spot Welds

Fig. 42. Filler Panel to Dash Panel Spot Welds

Fig. 48. Using MIG Welder For Plug Welds

TM-5-3820-256-24-5 Drilling System Well Rotary Truck Mounted Air Transportable 600 Feet Capacity Model LP-12 NSN 3820-01-246-4276 Manual
Page Navigation
536

SERVICE MANUAL 10. Drill out fourteen spot welds along top of door opening and separate side panel from roof inner panel (Fig. 46). Fig. 46. Side Panel to Roof Inner Panel Spot Welds 1. Drill Out These Welds 11. Drill out fifteen spot welds along bottom of door opening and separate side panel from sill side inner panel (Fig. 47). Note that on 80" wide cabs there are additional spot welds to be removed at lower front corner of door opening. 12. Drill out three or four additional welds along top edge of windshield opening as required to separate roof panels and raise roof panel sufficiently to permit removal of side panel from cab. IMPORTANT Be careful while removing side panel so as to avoid damage to roof panel. Fig. 47. Side Panel to Sill Side Inner Panel Spot Welds 1. Side Panel Assembly A. Front 2. Drill Out Welds B. View in Direction of Arrow B 3. Sill Side Inner Panel CTS-4065 PRINTED IN UNITED STATES OF AMERICA Page 27

Privacy Statement
Press Release
Contact