SERVICE MANUAL
Fig. 38 Location of MIG Weld Seams
1.
MIG Welds
Fig. 39. Side Panel to Outer Roof Panel Spot Welds
1.
Side Panel Assembly
2.
Inner Roof Panel
3.
Outer Roof Panel
4.
Drill Out Welds Along Drip
Moulding
A-A. Section thru Side Panel and
Outer Roof Panel
4.
Drill out spot welds along seam between back
panel and side panel and separate rear of side
panel from back panel (Fig. 40). Drill at outer
seam if for 90" wide cab.
5.
Drill out spot welds along seam at bottom of cab
and separate rocker panel from sill side inner
panel (Fig. 41).
Fig. 40. Side Panel to Back Panel Spot Welds (Right
Corner 90" Wide Cob Shown)
1.
Back Panel
2.
Back Panel Filler
3.
Side Panel Assembly
4.
Drill Out Welds (Outer Seams
Only)
A-A Section thru Back Panel and
Side Panel
Fig. 41. Rocker Panel to Sill-Slide Inner Panel Spot
Welds
1.
Drill Out Welds
2.
Rocker Panel
3.
Sill Side Inner Panel
A.
Front
CTS-4065
PRINTED IN UNITED STATES OF AMERICA
Page 25