TM 5-3825-225-14&PFigure 5-13. Bearing Cap.Figure 5-14. Thrust Washer Installation .(5)Rotate the upper thrust washer halves (3) by rotating them with a piece of wood until they can beremoved from recesses.NOTELightly oil thrust washers before Installing them. The steel faces of the thrustwashers should face Inward toward the bearing cap.(6)Install upper thrust washer halves (3) (see Figure 5-14).(7)Install lower thrust washer halves (4) and torque setscrews (30, Appendix F, Figure 49) to 85 lb.-ft. (115Nm).(8)Ensure that crankshaft end float is with-in limits 0.002-0.015 in. (0.0508-0.381mm) (see Figure 5-15).(9)Install rear main oil seal half housing (20) with setscrews (18).NOTEIf oil seals leak, replace them.(10) Install oil pan assembly (see paragraph 5-21).d.Crankshaft Removal (see Appendix E Figures 49 and 52).Figure5-15. Gaging Crankshaft End Float.(1)Remove starter and solenoid (see paragraph 4-52).(2) Remove flywheel housing and flywheel (see paragraph 5-17).(3)Remove crankshaft front pulley, timing case cover, timinggears, and injector pump drive hub (see paragraph 5-19).(4)Remove timing case back plate (see paragraph 5-19).(5)Remove oil pan and oil pump assembly (see paragraph 5-21)TA503365-15
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
