TM 5-3825-226-24
FUEL INJECTION PUMPS
DISASSEMBLE FUEL INJECTION PUMPS
start by:
a)
remove fuel injection pumps
1.
Remove the bushing (1) and seal from the
bonnet (2).
2.
Remove the ring (3) from the bonnet and barrel
(7). Remove the check valve (6) and spring (4)
from the bonnet.
3.
Remove the spring (8) and washer (5). Remove
the plunger (9) and sleeve (10).
NOTE:
Keep the plunger and sleeve with
their
respective
barrel
for
installation. Do not use plungers,
sleeves
and
barrels
with
other
plungers, sleeves and barrels.
ASSEMBLE FUEL INJECTION PUMPS
1.
Install the sleeve (4), plunger (5), spring (2) and
washer (3) on the barrel (1).
NOTE: Be sure the sleeve and
plunger are installed in their original
barrel and the large hole in the
plunger is up. The sleeve must be
installed with the thin flange up.
2.
Install the check valve and spring in the bonnet.
Connect the barrel and bonnet and install the
ring. Install the seal and bushing on the bonnet.
end by:
a)
install fuel injection pumps
3-67
