TM 5-3825-226-24
FUEL TRANSFER PUMP
9.
Install four bolts (7) that hold the body to the
housing.
10.
Put tool (D) in position so the camshaft will not
turn.
11.
Put sleeve (6) on the camshaft.
12.
Tighten the sleeve into position on the shaft with
4B4280 Washer of tooling (C) approximately .25
in. (6.4 mm). Tighten the sleeve the remainder
of the way with the 4N3371 Washer until the
sleeve is at bottom. This is the washer which is
on the tachometer drive shaft.
CAUTION: Do not hit the sleeve to
install. Damage to governor will
result.
13.
The end play of the camshaft must be .023 ± .018
in. (0.58 ± 0.46 mm) after sleeve (6) is installed.
end by: a) install fuel injection pump housing and
governor
3-70
