TM 5-3825-226-24
GOVERNOR
8.
Use tool (C) to install the shield the remainder of
the way on the camshaft. Move the metal
(stake) around the camshaft in two places on
the shield 180° ± 5° apart.
9.
If necessary install a new dowel (9) or seal (8)
as follows:
a) Put O-ring seal (8) on dowel (9).
b) Install the dowel in the fuel injection pump
housing until it is even with the machined
surface of the counterbore on the outside of the
housing.
10.
Put lever (15) on dowel (9) and install the ring to
hold it.
11.
Install screw (13), nut (14) and pin (11) in the
fuel injection pump housing.
12.
Put torque control group (12) in position and
tighten bolt (10) and the nut to hold the control
group.
13.
Install the gasket and cover (16) on the fuel
injection pump housing.
3-75
