TM 5-3825-226-24
GOVERNOR
14.
Install race (18), bearing (19), race (20) and ring
(21) on riser (17).
15.
Install tool (B) in the fuel injection pump housing
to keep it in time when it is installed on the
engine.
16.
Install riser (17) on the flyweight shaft with the
bearing toward the flyweight carrier. Lift the
flyweights up with a piece of wire and push the
riser forward.
17.
Put lever (23) in position in the fuel injection
pump housing. Make sure the lever is engaged
correctly in the groove of the riser.
18.
Put the O-ring seal on shaft (22) and install the
shaft in the fuel injection pump housing to hold
lever (23).
19.
Put spool (27) and ring (28) in position on seat
(26). Use tool (E) to install ring (29) on seat
(26).
20.
Install spring (25) and seat (26) in seat
assembly (24).
NOTE:
Turn spring (25) on seat assembly
(24) and seat (26) until it just makes
contact with the shoulders on the
seat assembly and seat. The seat
and seat assembly faces must be
parallel with each other after spring
(25) is installed. If not, remove the
spring and install it again.
21.
Install the small cover over the high idle
adjustment.
22.
Install spring (30) and seat assembly (24) on the
flyweight shaft.
3-76
