TM 5-3825-226-24
GOVERNOR
23.
Put 5S1454 Sealing Compound on the outside
diameter of the seal. Use tool group (D) to
install the seal in governor housing assembly
(31) with the lip of the seal toward the inside as
shown. Remove the sealing compound from
housing assembly (31) after the seal is installed.
24.
Put the lever assembly, spring (36) and lever
(32) in position on shaft assembly (33). Put
9M3710 Anti-Seize Compound on the outside
diameter of the spacer and install the spacer
and bolt (34) to hold lever (32) in position.
25.
Put lever assembly (38) in position in housing
assembly (31) with washers (35) and (37) on
each side of the lever assembly.
26.
Install shaft assembly (33) in housing assembly
(31) and install the two bolts to hold lever
assembly (38) to the shaft assembly.
27.
Install seat (39), springs (40) and (41) in housing
assembly (31).
CAUTION:
Both springs must make full contact
on seat (39) before they are installed
in the governor housing assembly. If
the springs do not make full contact
on the seat, high idle speed will not
be correct and low idle governor
surge can be the result. Low idle
setting without stability can also
result.
28.
Install the gasket and housing assembly (31) on
the fuel injection pump housing.
29.
Remove the fuel injection pump housing from
tool (A).
end by:
a) make an adjustment of the fuel system
setting (See FUEL SYSTEM in TESTING AND
ADJUSTING)
b) install fuel injection pump housing and
governor
3-77
