TM 5-3825-226-24
FUEL INJECTION PUMP HOUSING
DISASSEMBLE FUEL INJECTION PUMP HOUSING
start by:
a) remove fuel injection pumps
b) disassemble governor
c) remove fuel transfer pump
1.
Loosen the screws that hold the sleeve levers to
the shaft assembly.
2.
Remove screw (1) that holds lever assembly (2)
to the shaft assembly.
3.
Remove shaft assembly (5) from the housing
and remove sleeve levers (3) and lever
assembly (2).
4.
Loosen the screws that hold sleeve levers (6) to
the shaft.
5.
Remove the screw that holds lever (4) to the
shaft.
6.
Remove shaft (7) from the housing and remove
sleeve levers.
7.
Remove the lifter and roller assemblies (8) from
the housing with a magnet.
NOTE:
Put identification on the lifters (10)
and rollers (9) for installation in their
respective bores in the housing.
3-79
