TM 5-3825-226-24
GOVERNOR
22.
Disassemble the flyweight assembly as follows:
a)
Remove shaft (40) from carrier (41).
b)
Remove dowel (39) from shaft (40).
c)
Remove dowels (43) and weights (42) from
carrier (41).
ASSEMBLE GOVERNOR
Tools Needed
A
B
C
D
E
2P8315
Bracket Assembly
1
3P1544
Timing Pin
1
5P301
Driver
1
1P510
Driver Group
1
1.
Assemble
the
flyweight
assembly
as
follows:
a)
Put weights (4) in position on carrier (3) and
install dowels (5) to hold the weights.
b)
Install dowel (1) in shaft (2).
c)
Install shaft (2) in carrier (3).
2.
Install the fuel injection pump housing in tool (A).
3.
Install tool (B) to hold the camshaft.
4.
Put the flyweight assembly in position on the
camshaft.
NOTE: Be sure the pin that holds the
flyweight shaft is in position in the
back of the flyweight carrier before the
bolts are installed.
5.
Install bolts (6) that hold the flyweight assembly to
the camshaft. Tighten the bolts to a torque of 10
± 2 lb.ft. (14 ± 3 N•m).
6.
Remove tool (B) from the fuel injection pump
housing.
7.
Put shield (7) in position over the flyweights.
3-74
