TM 5-3825-226-24
GOVERNOR
DISASSEMBLE GOVERNOR
Tools Needed
A
B
C
D
2P8315
Bracket Assembly
1
5P302
Bar
1
3P1544
Timing Pin
1
1P1855
Pliers
1
start by:
a)
remove fuel injection pump housing and
governor
1.
Install the fuel injection pump housing on tool (A).
NOTE: Tool (C) was installed in the
groove (slot) in the fuel injection pump
camshaft when the fuel injection pump
housing and governor were removed.
2.
Remove bolts (2), housing assembly (1) and the
gasket from the fuel injection pump housing.
3.
Remove the two springs (4) and seat (3) from the
governor housing.
4.
Remove two bolts (7) that hold lever (10) to shaft
(6). Pull shaft (6) out of the governor housing and
remove washers (5) and lever (10).,
5.
If necessary, remove bolt (9) from shaft (6) and
remove lever (8), spring (11) and the lever
assembly from the shaft.
6.
Remove seal (12) from governor housing (1).
3-71
