TM 5-3825-226-24
OUTPUT TRANSFER GEARS
23.
Remove plug (23), tie seal and valve group
from the case assembly. Remove the poppet,
spring and plug from the valve body.
24.
Put blocks under gear (24) for support.
25.
Remove the bolts from shaft (22) and install
four 3/8” - 16 NC x 6 in. (15.2 cm) long guide
bolts as shown.
26.
Remove shaft (22). Remove the bearing cone
from the shaft.
27.
Remove gear (24) from the case. Remove the
bearing cone and spacer from the gear.
28.
Use tooling (A) and remove the bearing cups
and spacer from gear (24). Remove tie snap
ring from gear (24) if necessary.
ASSEMBLE OUTPUT TRANSFER
GEARS
Tools Needed
A
B
1P520
Driver Group
1
8S2328
Dial Test Indicator Group
1
1.
Install poppet (2), spring (3) and plug (4) in
valve body (1).
NOTE: Install plug (4) to a depth of .25 in. (6.35 mm)
from the end face of valve body (1).
2.
Install valve body (1) and the plug in the output
transfer gear case.
3.
Make a replacement of the ring in gear (7) if
necessary.
4.
Install spacer (6) in gear (7) from the small gear
side of gear (7).
5.
Lower the temperature of bearing cup (5) and
install it in the small gear side of gear (7).
3-223
