TM 5-3825-226-24
OUTPUT TRANSFER GEARS
27.
Heat bearing cone (31) in oil to a maximum
temperature of 275°F (135°C). Install bearing
cone (31) on input gear (30).
28.
Heat bearing cone (32) in oil to a maximum
temperature of 275°F (135°C). Install bearing
cone (32) on input gear (30).
29.
Install ring (33) on input gear (30). Install input
gear (30) in the transfer gears case.
30.
Heat seal carrier (34) in oil to a maximum
temperature of 275°F (135°C) for no more than
10 minutes. Make sure the part number on
carrier (34) can be seen and the hole in the
carrier is in alignment with the hole in the cage
assembly and install the carrier on cage
assembly (35). Install spring pin (36) in the
cage assembly.
31.
Install the seal rings on carrier (34).
32.
Lower the temperature of bearing cup (37) and
install it in cage assembly (35).
33.
Install cage assembly (35) in the output transfer
gears case. Install the locks and bolts that hold
the cage assembly in position.
34.
Use tool group (B) and check the input gear end
play. The end play must be .003 to .005 in.
(0.08 to 0. 13 mm). If the end play is not
correct, add or subtract shims from under the
rear bearing cage to get the correct amount of
end play. end by:
a)
assemble transmission
3-227
